"We investigate the potential of using high-resolution seismic methods for rock characterization and for targeting of gold deposits at the St. Ives gold camp. The application of seismic methods in hard-rock environments is challenged by complex structures, intrinsically low signal-to-noise ratio, regolith distortions, and access restrictions. If these issues can be addressed, then the unparalleled resolving power of reflection seismic can be used for mineral exploration. Appropriate spatial sampling of the wavefield combined with a survey geometry design and rigorous data processing to incorporate high fold and long offsets are necessary for creation of high-quality seismic images. In the hard-rock environment of Western Australia, accurate static corrections and multiphase velocity analysis are essential processing steps. This is followed by a rigorous quality control following each processing step. In such a case, we show that the role of reflection seismic could be lifted from mere identification of first-order structures to refined lithological analyses. Five deep boreholes with sonic logs and core sample test data wer eused to calibrate 2D seismic images. Despite seismic images were produced with relatively robust scaling it was possible to achieve reasonably high seismic-log correlation across three of the tightly spaced boreholes using a single composite wavelet. Amplitude-versus-offset (AVO) analysis indicated that gold-bearing structures may be related to elevated AVO effect and increased reflectivity. Consequently, partial stack analysis and acoustic and elastic inversions were conducted. These results and impedance crossplots were then evaluated against known gold occurrences. While still in the preliminary stages, hard-rock seismic imaging, inversion, and the application of AVO techniques indicated significant potential for targeting mineral reserves" -- Summary.

"A special challenge of hard rock exploration is to identify targets of interest within complex geological settings. Interpretation of the geology can be made from direct geological observations and knowledge of the area, and from 2D or 3D seismic surveys. These interpretations can be developed into 3D geological models that provide the basis for predictions as to likely targets for drilling and/or mining. To verify these predictions we need to simulate 3D seismic wave propagation in the proposed geological models and compare the simulation results to seismic survey data. To achieve this we convert geological surfaces created in an interpretation software package into discretised block models representing the different lithostratigraphic units, and segment these into discrete volumes to which appropriate density and seismic velocity values are assigned. This approach allows us to scale models appropriately for desired wave propagation parameters and to go from local to global geological models and vice versa. Then we use these digital models with forward modelling codes to undertake numerous 3D acoustic wave simulations. Simulations are performed with single shot and with exploding reflector (located on extracted geological surface) configurations" -- Summary.

"Researchers of DETCRC 3.1 project acquired substantial experience in seismic exploration of Nickel deposits across Yilgarn craton, Western Australia. There are many lessons learnt and various approaches trialled. The validity of the research conducted and the outputs achieved were verified against real field data provided by the sponsors and affiliates to DET CRC. Research quality was scrutinised by publishing in high level journals. In general high quality images are achieved over nickel rich Kambalda province that allowed for an accurate structural interpretation. Rock identification and characterisation is still challenging particularly due to lack of calibration of seismic images with borehole logs and borehole seismic. Several case histories are documented and briefly analysed. The difference between Komatiitic nickel deposit of Australia and Canada is also commented in light of seismic response and required technology for its detection" -- Executive summary.

"This document is intended to summarise the current state, understanding and the use of seismic reflection method for mineral exploration. Its primary objective is to provide a point of reference, based on actual case studies, for mineral explorers interested in the application of seismic methods to their project. It provides summary information (including the purpose of the survey, acquisition methods, geometry and cost, processing procedures and key findings) that are intended to provide the reader with an objective means of assessing the cost effectiveness of the technique with respect to exploration objectives. It is also aimed at exchange of information between DETCRC sponsors, affiliates and researchers. Finally we hope that this table will help in shaping future research efforts and direction within Project 3.1, regarding the application of seismic for mineral exploration.This is only initial work and it is hoped that it will evolve into a document or a catalogue that will be extensively used by the mineral industry to achieve their exploration objectives in more efficient and effective way" -- Executive summary.

"A light-hearted take on the Australian toilet paper shortage. With a lot of worry and fear in the world today (2020), it is important to be informed and make good decisions based on the facts at hand. Panic buying caused supply shortages for some products. In Australia, one of the bizarre products to fall to panic buying was toilet roll. This little book, produced as a light-hearted response, offers a reminder that there is always an alternative. Contained in this book are sixteen "sheets". It may be single ply, but we are sure you will agree the 70lb paper has plenty of bulk" -- from the introduction.

From Trash to Treasure is an intensely honest account of a life powerfully redeemed and is a demonstration of the goodness of God. Lee Habbershaw's journey to recovery from sexual abuse moved me to tears - sometimes in compassion, but often in joy. The book is rich with the landmark of life events and Biblical truths which, layer by layer, led Lee into the powerful teaching and counselling ministry she operates in today. This book could change your life (page 7)

A fun light story by Grammy of camping in the Vales with nighttime noises and shadows scaring all. She knew who was scurrying around the campsite. Would you like to know too? -- Publisher.

"Fixed safety cameras that detect red light running and speeding vehicles are known to be an effective method of controlling driver behaviour and producing road safety benefits. While no definitive best practice for choosing safety camera locations was found in the literature, there are a number of criteria that are frequently used and that make sense: locations with a high number of crashes (particularly injury crashes); locations with a high proportion of speeding vehicles; locations with high traffic volumes; locations with large numbers of unprotected road users (pedestrians and bicyclists); different camera types covering different areas of the road network; and deploying cameras widely throughout the road network. Evaluation of the effects of safety cameras on particular sites and as a whole can be attempted using a number of methodologies: changes in crash numbers before and after installation; changes in vehicle speeds before and after installation; and changes in offence detections from the time of installation onwards. There are limitations with each of these methodologies such that evaluating the effectiveness of an individual safety camera is often not possible. By tracking many safety camera sites for a long period of time, the effect of the safety cameras can be examined but there will always be other factors that may explain any observed changes. A true experiment could be conducted to determine safety camera effects but it would involve deliberate non-treatment of good candidate sites for many years. This study gives a reasonable set of principles for selecting safety camera sites and evaluating their effectiveness. However, the detailed processes for South Australia will depend on what data is available, the resources and funding that can be applied, and political and other considerations." -- page 3.

To evaluate bicycle passing distances in the Australian Capital Territory (ACT), specialised passing distance measurement devices (PDMDs) were installed on a sample of 23 cyclists who ride in the ACT. Passing distance data and GPS data was collected by cyclists using the PDMDs for a four week period, during a trial phase of a newly legislated minimum passing distance (MPD) rule The MPD rule requires drivers to provide more than 1 metre of space when passing a cyclist on a road with a speed limit of 60 km/h or below, and 1.5 meters of space when passing a cyclist on a road with a speed limit above 60 km/h.-- Abstract.

Institute of Ophthalmology., producer.

Material culture.

War films -- History and criticism.

City planning -- Remote sensing.

Beastie Boys (Musical group)

Prediabetic state -- Prevention.

Diabetes in pregnancy -- Treatment -- Popular works.

Smith, Steve.

Sacks, Oliver, 1933-2015 -- Interviews.

Fishery management -- United States -- History -- 20th century.

Self-actualization (Psychology)

Memory.

Motion pictures -- Reviews.

Dodd, Reg, 1940-

AIDS (Disease) -- Illinois -- Chicago -- Fiction.

Heredity -- Genetics.

Australian fiction.

McMillan, Peter -- Travel.

Recollection (Psychology) -- Poetry.

Women prisoners -- Fiction.

Families -- Fiction.

Chomsky, Noam -- Political and social views.

Environmental economics.

Religion and science -- History.

Hypertension -- Diet therapy -- Recipes.