Strategic Insights into the Global Electric Vehicle (EV) Battery Market Growth

The auxiliary DC control power system is considered the most crucial element of a protection, control, and monitoring system. The failure of the direct current (DC) control power can result in the inability of fault detection devices to identify faults,... Read more

The post Auxiliary DC power system used for fault detection, trip coils and remote operation appeared first on EEP - Electrical Engineering Portal.

To be honest, transmission and distribution networks are full of problems. But that’s nothing new, and you already knew that. This technical article will shed some light on solving some pretty severe problems in transmission and distribution networks by using... Read more

The post Controlling power system parameters through reactive power (VAr) compensation appeared first on EEP - Electrical Engineering Portal.

This technical article we will go through a number of existing applications for conducting a wide range of electrical studies. However, the practice says that studies involving load flow and fault analyses are the most commonly utilized programs in power transmission... Read more

The post Eleven most important calculations you can perform with power system analysis software appeared first on EEP - Electrical Engineering Portal.

The accurate measurement of the voltage, current or other parameter of a power system is a prerequisite to any form of control, ranging from automatic closed-loop control to the recording of data for statistical purposes. Measurement of these parameters can... Read more

The post How to make the right selection of a digital transducer for power system measurements appeared first on EEP - Electrical Engineering Portal.

This article will shed some light on how adding capacitors gives the distribution system the necessary reactive power to return the power factor to the required level. Capacitors act as a source of reactive energy, which accordingly reduces the reactive... Read more

The post A few practical ways to determine required reactive energy compensation for a power system appeared first on EEP - Electrical Engineering Portal.

In the world of power systems, synchronization and reactive power control are crucial to maintaining stability, efficiency, and reliability. Synchronizing various power sources, such as generators and grids, ensures they operate in harmony to meet the demand and support the... Read more

The post Synchronization and Reactive Power Control in Power System appeared first on EEP - Electrical Engineering Portal.

To be honest, the technology of energy storage in batteries is pretty hot nowadays. It’s smart for utilities worldwide to get in line to learn what it is and how countries can benefit from it. Battery Energy Storage Systems (BESS)... Read more

The post Is storing excess energy in batteries worth integrating into the power system? appeared first on EEP - Electrical Engineering Portal.

Electrical safety and lightning protection of medium voltage input and up to ±400 VDC output power system in ICT data centres and telecommunication centres

Solar Power Systems, an independent research firm, released a list of the top solar companies in Calif., Ariz., and Nev. to provide consumers and vendors with unbiased research.

Location: Electronic Resource- 

IEEE / Institute of Electrical and Electronics Engineers Incorporated

IEEE / Institute of Electrical and Electronics Engineers Incorporated

IEEE / Institute of Electrical and Electronics Engineers Incorporated

A new world record is making the future of solar energy look pretty bright.

･ First introduction for a geothermal power plant ･ Enhancing the operation and performance of power generating facilities in close cooperation with customers

YOKOHAMA, JAPAN (March 26, 2020) - Mitsubishi Hitachi Power Systems, Ltd. (MHPS) announced the following group company personnel changes effective March 31 and April 1, 2020.

YOKOHAMA, JAPAN (March 26, 2020) - Mitsubishi Hitachi Power Systems, Ltd. (MHPS) announced the following executive-level personnel changes effective June 19, 2020.  

･ Supporting an energy management system with low-CO2 distributed power generation and self-consignment ･ Switch to CO2-free hydrogen fuel planned for the future

･ High-efficiency power generating units built on M701S (DA) X series gas turbines effectively utilize steelworks gas emissions ･ Third order from Baotou Steel Group, reflecting strong confidence of MHPS' technology

･ Combined cycle operations scheduled to begin in November 2023 ･ Total plant output to increase 50%, from the current 600 MW to 900 MW

･ Top share with 37.2% of the global market, fifth time since 2014 ･ Contributing to a significant reduction in air pollutants, and improvement in the global environment

According to one aspect, an apparatus for computing a solution to a power flow problem for an electrical power system comprising a plurality of buses. The apparatus includes (a) at least one processor comprising a plurality of cores; and (b) memory coupled to the at least one processor for storing an admittance matrix for the power system, real power and reactive power for each bus, and an initial complex voltage for each bus; (c) wherein the at least one processor is configured to: (i) perform a Jacobi power flow calculation for each bus to determine the complex voltage for each bus, the Jacobi power flow calculation using the admittance matrix, the real power and reactive power for each bus, and the initial complex voltage for each bus as inputs, wherein at least two Jacobi power flow calculations are performed concurrently on the plurality of cores; (ii) calculate a power mismatch at each bus based on the complex voltages; and (iii) determine whether the Jacobi power flow calculations have converged based on the power mismatch and repeat (i) to (iii) if the Jacobi power flow calculations have not converged.

A system, method, and apparatus for providing three level inverter modulation is disclosed. In one embodiment, control signals can be provided to control a three level inverter in a power converter based on at least one feedback signal.

Apparatus and process for heating and melting a material in a susceptor vessel are provided wherein phase synchronized ac voltage is supplied from a separate power source to each one of at least two induction coils in separate zones around the vessel. Power magnitude from each source to an induction coil is controlled by pulse width control of the source's output voltage. Output frequency from each source is either fixed or variable based upon the electrically conductive state of the material. Optional electromagnetic stirring is achieved by establishing a phase shift between the voltage outputs of the power supplies after the material in the susceptor vessel has melted.

A method of damping power system oscillations include obtaining a time synchronized damping control signal from a remote location and determining a communication time delay in receiving the time synchronized damping control signal from the remote location. The time synchronized damping control signal is then modified based on a phase compensation factor and an amplitude compensation factor determined from the time delay. Finally, a damping signal is generated based on the modified time synchronized damping control signal.

A discharge device actively discharges a main capacitor in an electric-power system of an electric-drive vehicle and comprises a discharge branch of a circuit connected in parallel to the capacitor and including a discharge transistor biased to “conduction” mode when the capacitor must be discharged. A control device is connected to a “gate/base” terminal of and controls the transistor, biasing the transistor to the mode when the capacitor is required to fee discharged. A control transistor maintains the discharge transistor in a “non-conductive” state when the control transistor is in the mode. The control transistor is in the state for the discharge transistor to be in the mode. A safety capacitor is interposed between the terminal and a power supply and charges when the discharge transistor is in the mode, causing a progressive decrease of current at the terminal, until the discharge transistor is biased to the state.

An integrated power system suitable for simultaneously powering marine propulsion and service loads. The system includes: (a) at least one generator configured with at least first and second armature windings configured to output respective first and second alternating current power signals of different voltages, the at least two armature windings positioned within the same stator slots so that they magnetically couple; (b) at least first and second rectifier circuits coupled to said generator to convert said first and second alternating current power signals into first and second direct current power signals; and (c) a first load to which said first direct current power signal is coupled and a second load to which said second direct current power signal is coupled.

An on-demand electric power system for providing on-demand electric power in remote locations. The on-demand electric power system generally includes a protective housing, an engine-generator within the protective housing, a control switch electrically positioned between the engine-generator and an electric load, and a control unit in communication with the engine-generator and the control switch to control operation of the engine-generator along with electrical power to the electric load. The control unit detects when electrical power is required by an electric load and then first starts the engine-generator. After a period of time, the control unit then closes the control switch to provide electrical power to the electric load.

Controlling a power system in a mining truck includes receiving data indicative of an expected change in suitability of the mining truck for on-trolley operation, and outputting a control command to an actuating mechanism for a pantograph responsive to the data and prior to occurrence of the expected suitability change. A mining truck and power system are further provided, wherein a pantograph having an electrical contactor is adjusted between a first configuration contacting an overhead trolley line, and a rest configuration, responsive to data indicative of the expected suitability change.

A domestic combined heat and power system including a power unit, a heat-storage tank which receives waste heat of the power unit for storing heat in direct water, and a main heat exchanger connected to the heat-storage tank, being heated by a burner so as to use the water as hot water. A waste-heat heat exchanger filled with a heat-transfer medium is installed between the power unit and the heat-storage tank such that a waste-heat pipe is arranged in the form of a coil at one side inside the waste-heat heat exchanger, and a heat-storage pipe of the heat-storage tank is arranged in the form of a coil at the other side. Waste heat of the power unit is indirectly heat exchanged to the heat-storage tank through the heat-transfer medium. Costs and waste of energy consumption are reduced, and there is sharing of functions that are duplicated across the heat-storage tank.

A positive electrode active material includes: secondary particles obtained by aggregation of a plurality of primary particles. The primary particles include, core particles including a lithium composite oxide, and a layer that is provided on surfaces of the core particles and includes a lithium composite oxide. The lithium composite oxide included in the core particles and the lithium composite oxide included in the layer have the same composition or almost the same composition, and crystallinity of the lithium composite oxide included in the layer is lower than crystallinity of the lithium composite oxide included in the core particles.

Power system for supplying high voltage to an electron beam emitter, which is adapted to sterilize a packaging container or a packaging material by electron beam irradiation, the power system comprising a voltage multiplier for generating a high voltage, a first voltage measurement device for measuring an output voltage level of the voltage multiplier and providing a first measured voltage value, and an actuator for modifying the output voltage level of the voltage multiplier based on the first measured voltage value provided by the first voltage measurement device, characterized in that the power system further comprises a second voltage measurement device adapted to independently measure the output voltage level of the voltage multiplier and provide a second measured voltage value.

Redpaper, published: Mon, 20 Apr 2020

This IBM® Redpaper publication describes practical experiences to run SAP workloads to take advantage of IBM Power Systems I/O capabilities.

Redpaper, published: Mon, 20 Apr 2020

This IBM® Redpaper publication delivers SAP HANA architectural concepts for successful implementation on IBM Power Systems servers.

MicroStrategy is a business intelligence tool that allows data to be explored and visualized. MicroStrategy supports Hadoop environments as a data source. Read this article for details about how MicroStrategy Desktop was tested to integrate with and visualize data in Hortonworks Data Platform (HDP) on IBM POWER8.

Veristorm vStorm Enterprise makes data migration to Hadoop environments flexible, secure and easy. vStorm already supports data movement to Hadoop solutions running on Linux on IBM Power Systems. Read this article for details about how vStorm was tested to integrate with and move data specifically to Hortonworks Data Platform (HDP) on IBM POWER8.

Tableau is a business intelligence tool that allows data to be discovered and visualized. Tableau supports Hadoop environments as a data source. Read this article for details about how Tableau Desktop was tested to integrate with and visualize data in Hortonworks Data Platform (HDP) on IBM POWER8.

This article provides a list of ISV solutions that can augment the capabilities of Hortonworks Data Platform (HDP) running on Linux on IBM Power Systems. Solutions cover many categories including business intelligence (BI) tools, advanced analytics, and so on.

(United States Seventh Circuit) - Revived businesses' claims that they were sent unsolicited fax advertisements in violation of the federal Telephone Consumer Protection Act. Reversed a dismissal, in a case raising issues of standing to sue.

As demand for air travel grows, airport-related emissions are increasing and airports are challenged to reduce associated environmental impacts. In response, expanded regulatory programs and global climate protection initiatives are being developed that require the aviation industry—including U.S. airports—to implement new, clean technologies and to modify operational practices to reduce emissions. One effective option for reducing the emissions associated with aircraft auxiliary power units (APUs) and d...

IBM today announced that CipherHealth, a SaaS healthcare provider, has deployed IBM Power Systems™ infrastructure to run its technology platform that helps healthcare providers reduce re-admissions and improve the patient experience by providing effective patient engagement from pre-hospitalization through to post-discharge. The move to the new infrastructure has halved CipherHealth’s monthly infrastructure costs, and improved its data processing times by nearly 90 percent.

IBM today announced that according to results from International Data Corporation (IDC) Worldwide Quarterly Server Tracker®(June, 2017) IBM has achieved market growth by 3x compared with the total Linux server market which grew at +6 percent. The improved performance are the result of success across IBM Power Systems including IBM’s OpenPOWER LC servers and IBM Power Systems running SAP HANA as well as the OpenPOWER-Ready servers developed through the OpenPOWER Foundation.