Here are two screen capture of Before and After Autorouting my board. Padstacks have all been revised and corrected. The Capture Schematic is correct. All Footprints have been verified after Padstack revision. a new NETLIST generation have been done after some corrections made in Capture. I have imported the new Logic. I revised my Layout Cross Section as such: TOP, GND, VCC, BOTTOM. Both VCC and GND shapes have been assigned to their respective logical GND and VCC Nets (verified). Yet, I still have the Autorouter to systematically use extra vias to make GND and VCC connections to the VCC and GND planes. Where a simple utilisation of the part padstack inner layer would have been indicated. What Im I missing ?